Figure 36: Adding The Second Member To A J Series Cluster; Figure 37: Cluster Member Icons; Activating The Cluster Members - Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1 Administration Manual

Copyright © 2010, Juniper Networks, Inc.
A plus sign appears next to the cluster icon in the Device Manager indicating that the
cluster now has members. The New Cluster Member dialog box re-appears for the
second cluster member, as shown in Figure 35 on page 171.
Enter a name and color for the second member and select Model Device,
5.
Leave the Keep Adding Other Cluster Members box unchecked.
6.
Set the Member ID to 1.
7.

Figure 36: Adding the Second Member to a J Series Cluster

Click Finish.
8.
If you expand the cluster icon in the Device Manager, you will see the new cluster members,
as shown in Figure 36 on page 172.

Figure 37: Cluster Member Icons

Activating the Cluster Members

When the cluster has been properly installed, activate the cluster as follows:
Chapter 4: Adding Devices
163