Verifying Imported Device Configurations - Juniper NETWORK AND SECURITY MANAGER 2010.2 - ADMINISTRATION GUIDE REV1 Administration Manual

Verifying Imported Device Configurations

Copyright © 2010, Juniper Networks, Inc.
For example:
set system services outbound ssh client nsm wei secret 123456789
services netconf device-id abcdef 10.150.42.16 port 7804
Establish the SSH connection with the network management system.
3.
For a gateway or router with a single Routing Engine, or for a single EX Series switch:
% commit
For an EX Series virtual chassis, an SRX virtual chassis, or for a router with redundant
Routing Engines:
% commit synchronize
Synchronizing the commit operation ensures that NSM connects to the backup
Routing Engine following failover of the master Routing Engine.
The device software initiates the TCP connection to NSM and identifies itself using
the specified device ID and HMAC. The two sides then engage in SSH transport layer
interactions to set up an encrypted tunnel. NSM authenticates itself to the device
based on user name and password.
Confirm Connectivity and Import the Device Configuration into NSM
In NSM, validate connectivity with the device, and then import the device configuration:
In the Device List, verify the connection status of the newly added device. The status
1.
changes from "Never connected" to "Up."
If the configuration status is "device platform mismatch," you selected the wrong
device platform when adding the device into NSM. Delete the device from NSM
and add it again using the correct device platform.
If the configuration status shows "device firmware mismatch," you selected the
wrong managed OS version when adding the device into NSM. Delete the device
from NSM and add it again using the correct managed OS version.
Import the device configuration:
2.
Right-click the device in the Device Manager and select Import Device from the
a.
list.
In the Device Import Options dialog, check Summarize Delta Config if desired.
b.
Click OK, and then clickYes.
The Job Information dialog shows progress, or you can monitor progress in Job
Manager.
The next step is to verify the imported configuration using the Device Monitor or the
Device Manager. See "Verifying Imported Device Configurations" on page 127 for details.
After importing a device, verify that all device information was imported as you expected.
Chapter 4: Adding Devices
127