Using Central Manager
Copyright © 2010, Juniper Networks, Inc.
NOTE: When a J Series device is managed in central manager mode, if you
select an IDP rulebase rule and specify an IP address for the source and
destination instead of "any," the rule policy is not pushed to the device.
Device Management Mode
In device management mode, you can use the NSM Device Editor to manage the complete
device configuration. A device does not reference a central policy or central manager
object. The device is not affected by any VPN manager configurations setup within NSM
for policy-based VPNs.
You can update the latest configuration to the device. Later, you can reimport the latest
configuration from the device to determine any configuration differences and so on.
You can use the NSM UI to switch from the central management to device management
mode. This operation disconnects the device from the policy manager, central object
manager, and the VPN manager.
NOTE: You cannot switch a J Series or SRX Series device from central
management mode to device management mode if the device has an
assigned policy.
This section provides procedures for the following tasks for Central Manager super users:
"Adding a Regional Server Object" on page 631
"Deleting a Regional Server Object" on page 632
"Logging into a Regional Server" on page 632
Adding a Regional Server Object
For a Central Manager administrator to log onto a regional server, one of the regional
server administrator credentials must be used and linked to the Central Manager
administrator.
The following procedure assumes that a Central Manager administrator is logged onto
a Central Manager client.
To add a regional server object:
In the main navigation tree, select Object Manager > Regional Server.
1.
Click the Add icon in the toolbar.
2.
Enter the following information for the regional server you want to add.
3.
Name
IP address
Chapter 13: Central Manager
631
Need help?
Do you have a question about the NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1 and is the answer not in the manual?
Questions and answers