Table of Contents
Advertisement
CHAPTER 4
Adding Devices
Copyright © 2010, Juniper Networks, Inc.
This chapter provides information about adding Juniper Networks devices to your network.
These devices can include routers and switches, as well as the security devices that
protect your network against malicious traffic.
Juniper Networks Network and Security Manager (NSM) can manage all Juniper Networks
devices running ScreenOS 5.x and later, IDP 4.0 and later, Junos 9.0 and later, IC 2.2 or
later, or SA 6.3 or later. NSM can also manage vsys configurations, NetScreen Redundancy
Protocol (NSRP) clusters, Junos Redundancy Protocol (JSRP) clusters, vsys clusters,
and extranet devices.
NOTE: NSM does not support NetScreen-5 devices, NetScreen-100 devices,
or NetScreen-1000 devices. NSM supports the following ScreenOS releases:
5.0r11, 5.1r4, 5.2r3, 5.3r10, 5.4r11, 6.0r2, 6.1r4, 6.2 and 6.3.
Before you can manage a device with NSM, you must add the device to the management
system. NSM supports adding individual devices or many devices at a time.
NOTE: If you have been managing your IDP Sensors using the IDP
Management Server and UI, you should migrate your Sensors instead of
adding them manually. Refer to the IDP-NetScreen-Security Manager Migration
Guide for procedures and additional information.
Use Rapid Deployment (RD) to quickly add ScreenOS devices in nontechnical
environments with no staging requirements.
This chapter contains the following sections:
About Device Creation on page 98
Before You Begin Adding Devices on page 100
Supported Add Device Workflows by Device Family on page 111
Importing Devices on page 112
Modeling Devices on page 130
Using Rapid Deployment (ScreenOS Only) on page 139
97
Advertisement
Table of Contents
