Adding A Destination Nat Rulebase; Adding A Rule Set To A Destination Nat Rulebase - Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1 Administration Manual

Network and Security Manager Administration Guide

Adding a Destination NAT Rulebase

Adding a Rule Set to a Destination NAT Rulebase

544
To configure a destination NAT policy, the first step is to add a destination NAT rulebase
to this policy. For more information on adding a destination NAT rulebase to a policy, see
"Adding a Destination NAT Rulebase" on page 544.
To add a destination NAT rulebase:
From , select
Policy Manager
1.
Select the policy to which you want to add a destination NAT rulebase. The
2.
window appears.
Policy
If no policies are listed, then you must create a new policy and proceed to add a
rulebase to it.
Click ( ) at the upper right of the
3. +
Select >
NAT Policies Add Destination NAT Rulebase
in the policy.
The next step is to add rule sets to this rulebase. For more information on adding a
destination NAT rule sets to the rulebase, see "Adding a Rule Set to a Destination NAT
Rulebase" on page 544.
To add a rule set to the destination NAT rulebase:
Click ( ) at the upper left corner of the
+
1.
Select Add Rule Set to add a new rule set. The
2.
Here, you must specify a unique name for the rule set and specify the source through
which the traffic enters the private network, as follows:
Enter a name in the
a.
Select the source from the
b.
Source can be one of the following:
Routing Instance —Select the routing instance from the list.
In general, the list displays the routing instances configured within a specific
device or just the shared routing instances depending on whether the
From Device check box is selected (default) or not and can have the following
values:
The default routing instance (
use this routing instance, if you do not wish to configure anything new.
Other routing instances, if you have added them previously. To add a new
routing instance, use
—Select the zone from the list.
Zone
.
Policies
window.
Security Policy
Destination NAT
New Rule Set
Name field.
drop-down list.
Source
), which ships with the device. You can
default
>
Object Manager Routing Instance Objects
Security
. The tab appears
Destination NAT
tab.
dialog box appears.
Select
.
Copyright © 2010, Juniper Networks, Inc.