Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1 Administration Manual page 471

Table 42: Destination NAT Configuration Options (continued)
Tab Field
tab:
Address IP Address
Address
To Range/Port
Copyright © 2010, Juniper Networks, Inc.
Function
Specify a single IP address.
IP
tab: —Specify an address
To Address
range.
—Specify the optional port
Port
number.
Configuring Proxy ARP
To configure proxy ARP:
In the dialog box, enter the name of the interface. To navigate to this
New Interface
1.
dialog box, see steps 1 to 4 of "Adding a Destination NAT Object" on page 420.
Specify the hosts (range of IP addresses) whose ARP requests this device must accept,
2.
as follows:
Click and select (+) to configure the start of the address range in the
Address
dialog box.
Click and configure the end of the address range.
To
Click .
OK
Click . Proxy ARP is now configured.
3. OK
Editing a Destination NAT Object
To edit a destination NAT object:
Select
Object Manager
1.
dialog box appears.
Select a destination NAT object to edit.
2.
Select the Edit icon at the top of the screen. The
3.
appears.
Select the device to edit.
4.
Select the Edit icon. The
5.
Edit the values of the destination NAT object.
6.
Click .
OK
7.
Action
Enter an IP address.
Enter an IP address in the
Enter a port number in the
> >
Junos NAT Objects Destination NAT
JunosDestination NAT
Junos Destination NAT dialog box appears.
Chapter 8: Configuring Objects
field.
To Address
field.
Port
New
. The
Destination NAT
dialog box
421