Figure 61: Applying A Configuration Group; Figure 62: Configuration Group Applied - Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1 Administration Manual

Copyright © 2010, Juniper Networks, Inc.
In the device object configuration tree, right-click Interfaces.
1.
Select Apply/Exclude Config Groups from the list. The Apply/Exclude Config Groups
2.
dialog appears, as shown in Figure 61 on page 227.

Figure 61: Applying a Configuration Group

Select the desired configuration groups from the Available Config Groups list, and
3.
then click Add. The Available Config Groups list includes all configuration groups
created in the device object.
The configuration group and icon move to the Applied Config Groups list.
Click OK to apply the configuration group.
4.
NOTE: The first configuration group in the list has the highest priority. This
convention is the reverse of the ordering for templates, where the last
template in the list has the highest priority.

Figure 62: Configuration Group Applied

Chapter 5: Configuring Devices
227