Table of Contents
Advertisement
Copyright © 2010, Juniper Networks, Inc.
NOTE: After saving a configuration group entity, you cannot change
its key field. Specifically, after saving an interface definition, you cannot
change its name.
Click the Add icon again and name the second entry with a wildcard character <*>.
f.
Include the angle brackets, because they are required by the Junos syntax.
In the Speed field, set the speed to 1g and click OK.
g.
The configuration group icon appears next to the two interface entries in the group,
and next to each element in the tree above the interface entries. See Figure 60 on
page 225. Mouse over the icons to see a summary of what has been set and where
the information came from.
Figure 60: Adding a Configuration Group
Click OK to save the configuration group. The new configuration group appears in the
6.
Config Groups List.
Chapter 5: Configuring Devices
225
Advertisement
Table of Contents
