Editing A Source Nat Rule Or Rule Set - Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1 Administration Manual

Network and Security Manager Administration Guide

Editing a Source NAT Rule or Rule Set

542
Specify one of the following actions:
e.
—Do not perform source NAT.
Off
Pool —Use the specified user-defined address pool to perform source NAT. The
values are listed only if have configured the pools, previously. For configuring a
pool, see "Configuring Source NAT Objects" on page 417.
If you wish to configure persistent NAT, see "Editing a Source NAT Rule or Rule
Set" on page 542.
Interface —Use the egress interface's IP address to perform source NAT.
Click .
OK
f.
A rule with the specified name gets created and is displayed in the
From the Security Policy window, select a row and then right-click on a column to edit
the values. Depending on whether you have selected a rule or a rule set, you may get
some or all of the following actions to perform:
Under the Name header:
—Enables you to add rules to the rule set from the
Add Rule
Specify the values and click
Add Source —Enables you to view and modify the source that you set previously.
Under the header:
From
Zone/RJ/Interface > View/Modify Source
that you set previously.
:
Src Address
Edit —Enables you to cut, copy, and paste the values that are within this field.
—Enables you to add additional sources.
Add Src address
Edit Address —Enables you to edit the address of the selected source.
—Enables you to delete a source.
Delete Address
Under the header:
To
>
Zone/RJ/Interface View/Modify Destination
destination that you set previously.
:
Dest Address
— Enables you to cut, copy, and paste the values that are within this field.
Edit
—Enables you to add additional destinations.
Add Dest address
.
OK
—Enables you to view and modify the source
—Enables you to view and modify the
Copyright © 2010, Juniper Networks, Inc.
Security Policy window.
dialog box.
New Rule