Table of Contents
Advertisement
Network and Security Manager Administration Guide
Reference Point Pane
Log Viewer
Reports Viewer
Using Security Explorer
734
Use the Reference Point pane to view a list of reference objects. Next to the graph, a list
of the possible initial objects appears:
Address objects—For host/network selection. The selected host appears in a Peer
Graph, with selected network in a Outbound Service graph.
Service objects—Displayed in an Outbound IP graph.
IDP Attacks—Displayed in an Attack-Network graph.
Context objects—Displayed in a Value graph.
Double-click on an object to set it as a point of reference in the main graph.
Use the Logs tab in the viewer that appears below the main graph to view all logs related
to the point of reference that you have selected.
Use the Reports tab to generate and view one of the following reports in Security Explorer:
Top Alarms
Top Traffic Alarms
Top Traffic Logs
Top IDP/DI Attacks
Top Screen Attacks
Top Destination IPs
Attacks over time
Attacks by severity
Attacks by flag
Critical severity attacks
High severity attacks
Use the Source/Destination Address pull-down menu to view these reports based on
either the Source IP or Destination IP.
Use the time duration pull-down menu to view data in these reports during a specific
time frame. You can select to view data from the last 24, 12, 8, 4, 2, 1 hours.
You can launch the Security Explorer in any of the following ways:
From the Security Monitor tree node, select Security Explorer.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
