Figure 105: View Category And Severity Filters; Table 102: Log Viewer Navigation Controls; Log Viewer Status Bar; Navigating The Log Viewer - Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1 Administration Manual

Network and Security Manager Administration Guide

Table 102: Log Viewer Navigation Controls

Scroll Bar Components

Searching Log Entries

764

Log Viewer Status Bar

The status bar of the Log Viewer summarizes the filters applied to log entries in the log
entry list. The status bar displays the filter type description.
For example, Figure 105 on page 764 shows the status bar for log entries that are filtered
by Category and Severity:

Figure 105: View Category and Severity Filters

To view filter details, place the cursor over the filter type.

Navigating the Log Viewer

Using the side scroll bar, you can navigate through hundreds of log entries quickly and
precisely, as shown in Table 102 on page 764:
Function
Jump to top of log entry list.
Page up within log entry list.
Scroll up within log entry list.
Use the slider to move up or down within log entry list. The farther you drag the slider from
the center, the faster you scroll through the log entry list.
Scroll down within log entry list.
Page down within log entry list.
Jump to bottom of log entry list.
Log entries higher in the list are older than log entries at the bottom of the list. To navigate
through log entries based on a specific time, use the Log Timeline (for details, see "Log
Timeline" on page 765).
The Log Viewer can receive thousands or even millions of log entries each day. To quickly
locate a specific log entry or logs, use the log searching tools in Table 103 on page 765.
Copyright © 2010, Juniper Networks, Inc.