Figure 106: Log Viewer Time Slider; Figure 107: Log Viewer Time Display - Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1 Administration Manual

Network and Security Manager Administration Guide
766

Figure 106: Log Viewer Time Slider

Using Time Entry
You can also enter a date and time into the log timeline directly. Enter the date and time,
and click Go as shown in Figure 107 on page 766.

Figure 107: Log Viewer Time Display

Using Time Blocks
To change the log timeline intervals, select a specific time block or use the Out and In
buttons. From left to right, the time blocks are:
14 days
7 days
3 days
1 day
12 hours
6 hours
3 hours
1 hour
30 minutes
1 minute
Click the Out button to select the time block to the left of the currently selected time
block. Click the In button to select the time block to the right of the currently selected
time block. Alternatively, you can use the mouse wheel on your mouse to adjust the time
interval.
Copyright © 2010, Juniper Networks, Inc.