Adding Rules To The Bsg Transaction Rulebase - Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1 Administration Manual

Network and Security Manager Administration Guide

Adding Rules to the BSG Transaction Rulebase

536
To add rules to a BSG Transaction rulebase:
Select in the navigation tree.
Policies
1.
Select a policy to which you want to add a BSG transaction rulebase.
2.
Click ( ) at the upper right of the
3. +
Select >
Voice Policies Add BSG Transaction Rulebase.
4.
appears in the policy window.
Click at the upper right of the
5. (+)
a new policy. Select
Add Term
Configure the rules in the policy. Right-click on each column to
6.
or
Revert to template or default value.
conditions to be matched:
Src address Enter the source address of the SIP request.
Select the method of request: invite, message, options, publish, refer,
Method
subscribe.
Request URIs The uniform resource identifier of the request source. Enter a regular
expression.
Enter a regular expression.
Contacts
Select the desired action for the rule under the
7.
Accept the traffic and send it to its destination.
Accept
Do not accept the traffic and return a rejection message. You can log or
Reject
sample rejected traffic.
Trace messages are accepted by this policy.
Trace
Add or edit the route for the incoming request. You can set the egress service
Route
point or the next hop for the request.
View the admission controller applied to the policy in the
8.
Right-click on the
9. Install On
transaction policy.
View the applicable shared objects in the drop-down list in the
10.
section of the window. You can add, edit, delete and search for shared objects
Policy
such as BSG Service Points and Admission Controllers.
Add, delete, edit and search for policy sets in
11.
policy window.
window.
Policy
window. Select
Terms and Policies
to add a term to a rule in the policy.
Under the header, set the following
From
header. The actions are: .
Then
column to select a target device on which to install the
Policy Sets
Copyright © 2010, Juniper Networks, Inc.
The tab
BSG Transactions
to add
Add Policy
Add, Edit, Filter, Delete
Admission Controller column.
Shared Objects for
section to the right of the
,