Figure 48: View Denial Of Service Defense Values From Dos Template - Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1 Administration Manual

Network and Security Manager Administration Guide
206
a. Add a NetScreen-208 security device to the management system, and model the
configuration. Be sure to configure the device as running ScreenOS 5.0.
b. In the navigation tree, select Device Manager > Devices. Double-click the
NetScreen-208 device icon to open the device editor.
c. Select Info > Templates in the device navigation tree. Click the Edit icon in the
Templates screen. The Edit Templates dialog box appears.
d. Select the DoS template.
e. Click OK in the Edit Templates dialog box.
Verify that the DoS template values have been applied to the device:
3.
a. Select Network > Zone in the device navigation tree. Double-click the untrust zone.
The untrust-Predefined Zone dialog box appears.
b. Select Screen > Denial of Service Defense and review the values applied by the
template, as shown in Figure 48 on page 206.

Figure 48: View Denial of Service Defense Values from DoS Template

Create a second template that sets a different value for a SCREEN option than was
4.
set in the DoS template:
a. In the navigation tree, select Device Manager > Devices Templates, click the Add
icon, and then select ScreenOS/IDP Template. The New Device Template dialog
box appears.
b. In the Info screen, enter DoS2 in the Name field.
c. In the template navigation tree, select Network > Zone. The Zone configuration
screen appears.
d. Click the Add icon in the Zone configuration screen and select Pre-Defined Security
Zone—trust|untrust|dmz|global. The Predefined Zone dialog box appears.
Copyright © 2010, Juniper Networks, Inc.