Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1 Administration Manual page 184

Network and Security Manager Administration Guide
134
Click Next. The Specify Connection Settings dialog box opens. Enter the connection
4.
information:
Enter the IP Address of the device.
Enter the device administrator name.
Enter the device administrator password.
Enter the device root password.
NOTE: All passwords handled by NSM are case-sensitive.
Set the connection method to SSH Version 2.
Click Next to display the Verify Device Authenticity dialog box.
5.
Click Next.
6.
After NSM autodetects the device, click Next to activate the device in NSM.
7.
Click Update Now to update the configuration on the device with the settings from
8.
the modelled device.
If you do not update the configuration now, you will have to do it manually later by
right-clicking the device and selecting Update Device.
Updating the device also pushes the Juniper Networks Recommended policy to the
device.
After update is complete, the device status displays as "Managed", indicating that the
device has connected and the management system has successfully pushed the device
configuration.
Junos Devices
To activate a Junos device (or EX Series virtual chassis) with a static IP address:
Check the device configuration state by holding your mouse cursor over the device in
1.
Device Manager, or by checking the configuration status in Device Monitor. The device
configuration state should display "Modeled", indicating that the management system
is waiting for the device to connect.
Right-click the device and select Activate Device. The Activate Device wizard begins.
2.
Select Device deployed and IP is reachable.
3.
Click Next and enter the connection information:
4.
Enter the IP Address of the security device.
For a Junos device with redundant Routing Engines, provide the IP address of the
master Routing Engine.
Enter the device administrator name and password.
Copyright © 2010, Juniper Networks, Inc.