Ive Vpn Monitoring - Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1 Administration Manual

IVE VPN Monitoring

Copyright © 2010, Juniper Networks, Inc.
Specify the AutoConnect VPN parameters to complete the procedure.
5.
In the configuration area of this VPN, click the AutoConnect VPN Parameters link.
The AutoConnect VPN Parameters dialog box appears.
Click the Import Gateway and AutoKey Parameters button to import the existing
hub-and-spoke configuration for the hub and spoke. You can configure the VPN
and gateway by using ACVPN-Dynamic(Mains) or ACVPN-Profile(Hub) parameters
in the navigation tree.
Click the Save button to save the VPN configuration.
Verify the NHRP settings for the hub and spokes, virtual router, and spoke virtual router.
6.
For interface NHRP settings:
7.
In the configuration area of this VPN, click the Device Tunnel Summary link.
Right-click the tunnels, and then click Edit Interface. The Tunnel Interface dialog
box appears.
Click Protocol > NHRP. Ensure that the Enable NHRP check box is selected.
Click OK.
For the hub virtual router NHRP settings:
8.
In the configuration area of this VPN, click the Device Tunnel Summary link.
Right-click the tunnels, and then click Edit Virtual Router. The Virtual Router dialog
box appears.
Click Dynamic Routing Protocol > NHRP > Parameters.
Verify that the ACVPN-Profile setting has been populated.
Click OK.
For the spoke virtual router NHRP settings:
9.
In the configuration area of this VPN, click the Device Tunnel Summary link.
Right-click the tunnels, and then click Edit Virtual Router. The Virtual Router dialog
box appears.
Click Dynamic Routing Protocol > NHRP > Parameters.
Verify that the NHS IP Address field has been populated.
Click OK.
NSM real-time monitoring is available on Secure Access and Infranet Controller devices.
For more information, see "Realtime Monitoring" on page 659.
Chapter 12: Configuring VPNs
627