Table of Contents
Advertisement
Copyright © 2010, Juniper Networks, Inc.
NOTE: After importing a NetScreen-5GT device that uses extended port
mode, NSM displays the modes as "ns5GT-Trust-Untrust-DMZ" and sets
the license mode to Extended.
To check the device configuration status, mouse over the device in Device Manager (you
can also check configuration status in Device Monitor). The device status displays as
Managed, indicating that the device has connected and the management system has
successfully imported the device configuration.
The next step is to verify the imported configuration using the Device Monitor or the
Device Manager. See "Verifying Imported Device Configurations" on page 128 for details.
IDP Sensors
IDP Sensors running versions of the IDP software earlier than 4.0 cannot be imported. If
those Sensors are already being managed by IDP Manager, migrate your IDP Management
Server and the Sensors with it. Refer to the IDP-NetScreen-Security Manager Migration
Guide for more information.
You need to upgrade unmanaged Sensors to 4.0 or later before adding them to NSM.
See the IDP Installer's Guide for more information.
To import an IDP 4.0 device with a known IP address:
From the domain menu, select the domain in which to import the device.
1.
In Device Manager, select Devices.
2.
Click the Add icon and select Device to open the Add Device wizard.
3.
Select Device Is Reachable (default).
4.
Click Next. The Specify Connection Settings dialog box opens.
5.
Enter the following connection information:
6.
Enter the IP Address of the Sensor.
Enter the username of the device administrator.
Enter the password for the device administrator.
Enter the password for the device root user.
NOTE: All passwords handled by NSM are case-sensitive.
Select the connection method (SSH Version 2) and the port number for the selected
service.
Select the Port Number. The default (port 22) is recommended.
Chapter 4: Adding Devices
115
Advertisement
Table of Contents
