Figure 63: Excluding A Configuration Group; Editing A Device Object That Uses Configuration Groups - Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1 Administration Manual

Network and Security Manager Administration Guide
Excluding a Configuration Group

Editing a Device Object That Uses Configuration Groups

228
Configuration groups applied at a higher level in the configuration can be explicitly
excluded at lower levels. To exclude a configuration group from a branch of the
configuration, follow these steps:
Right-click on the branch and select Apply/Exclude Config Groups from the list.
1.
The Apply/Exclude Config Groups dialog box appears. All configuration groups applied
at higher levels in the configuration appear in the Inherited Config Groups list. Figure
63 on page 228 shows an example.

Figure 63: Excluding a Configuration Group

In the Inherited Config Groups list, select the configuration groups you want to exclude,
2.
and then click Add,
The selected configuration group names move to the Excluded list.
Click OK to exclude those groups from that part of the configuration.
3.
After you apply the configuration group, tooltip icons identify where configuration groups
have affected the configuration. You can mouse over these items to display information
about them.
When you edit an entity that was derived from a configuration group, the new value
overrides the value derived from the configuration group. The tooltip icon changes so
you can easily identify which entries have been overridden,
Copyright © 2010, Juniper Networks, Inc.