Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1 Administration Manual page 183

Copyright © 2010, Juniper Networks, Inc.
Check the device configuration state by holding your mouse cursor over the device in
1.
Device Manager, or by checking the configuration status in Device Monitor. The device
configuration state should display "Modeled", indicating that the management system
is waiting for the device to connect.
Right-click the device and select Activate Device to display the Activate Device wizard.
2.
Select Device Deployed and IP is reachable.
3.
Click Next and enter the connection information:
4.
Enter the IP Address of the security device.
Enter the device administrator name and password.
NOTE: All passwords handled by NSM are case-sensitive.
Select the connection method (Telnet, SSH version 1, SSH version 2) and the port
number for the selected service.
If you selected Telnet, click Next and go to Step 5.
If you selected an SSH version, click Next. The Verify Device Authenticity dialog box
opens. The device wizard displays the RSA Key FingerPrint information. To prevent
man-in-the-middle attacks, you should verify the fingerprint using an out-of-band
method.
After NSM autodetects the device, click Next to activate the device in NSM.
5.
Click Update Now to update the configuration on the device with the settings from
6.
the modelled device.
If you do not update the configuration now, you will have to do it manually later by
right-clicking the device and selecting Update Device.
The Job Information box displays the job type and status for the update. When the
job status displays successful completion, click Close.
After the update finishes, the device status displays as "Managed", indicating that the
device has connected and the management system has successfully pushed the device
configuration.
IDP Sensors
To activate an IDP Sensor with a static IP address:
Check the device configuration status by holding your mouse cursor over the device
1.
in Device Manager (you can also check configuration status in Device Monitor). The
device configuration status should display "Modeled", indicating that the management
system is waiting for the device to be activated.
Right-click the device and select Activate Device to display the Activate Device wizard.
2.
Select Device deployed and IP is reachable.
3.
Chapter 4: Adding Devices
133