Configuring Device Servers - Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1 Administration Manual

Copyright © 2010, Juniper Networks, Inc.
Table 78: Server Information (continued)
Item
Server Type
IP Address
Device Server Manager Port
IDP Device Server Manager
Port
DMI Device Server Manager
Port
IP Address of Secondary
Server

Configuring Device Servers

You can also add and configure a Device Server. You might need to configure a Device
Server when installing the GUI Server and Device Server on separate servers, or when
installing the management system with High Availability (HA) enabled.
You can configure the following parameters on a Device Server:
Name—Name of the Device Server.
IP Address—IP address of the Device Server.
Server Type—Either Device Server or Device Server Cluster. If you are installing the
management system with HA enabled, you need to configure the Device Server as part
of an HA Cluster. After you specify that a Device Server will act as a Device Server
Cluster, you can access additional tabs allowing you to further configure cluster details
including the IP Address and port number of the secondary server, and e-mail
notification.
Device Server Manager Port—The port is set to 7800 by default. This field is read only.
IDP Device Server Manager Port—The port is set to 7803 by default. This field is read
only.
DMI Device Server Manager Port—The port is set to 7804 by default. This field is read
only.
Device Server ID—A unique ID assigned by NSM to each Device Server.
Mapped IP Address (MIP)—If applicable, you can define multiple mapped IP addresses.
Device Polling—The Device Server polls security devices it manages for Device, VPN,
NSRP, or Interface statistics every 300 seconds by default. If you wish to change this
behavior, you can edit the interval, using the Device Polling tab.
Description
Whether the current server is Device Server, Device Server Cluster,
GUI Server, or GUI Server Cluster.
IP address of the server.
The port open on the Device Server for security devices running
ScreenOS 5.0 and later. (Read Only)
The port open on the IDP Device Server for security devices.
The port open on the DMI Device Server for security devices.
IP address of the secondary server.
Chapter 17: Realtime Monitoring
699