Table 75: Idp Cluster Monitor; Table 76: Idp Cluster Summary; Monitoring Idp Clusters; Viewing Idp Cluster Summary Information - Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1 Administration Manual

Network and Security Manager Administration Guide

Monitoring IDP Clusters

Viewing IDP Cluster Summary Information

696
Table 74: RTO Counters Details (continued)
Item
Counter to Set
Counter to Lost Peer
Counter to Group Detach
If you have implemented IDP clusters for the purpose of redundancy, you can use the
IDP Cluster Monitor to get an at-a-glance status of your IDP sensors that are in clusters.
Table 75 on page 696 describes all of the information available from the IDP Cluster
Monitor:

Table 75: IDP Cluster Monitor

Item Description
Name Name of the cluster.
Status Status of the cluster (OK, Warning, or Fail).
Domain Domain in NSM in which the source IDP cluster is managed.
Click IDP Cluster Monitor to view a summary of the top-level information on all IDP
clusters. From the IDP Cluster Summary, you can view the following details about a
specific cluster:
Key details describing the cluster (such as name, Status, Cluster ID)
HA mode
Table 76 on page 696 describes all of the information that is available from the IDP Cluster
summary:

Table 76: IDP Cluster Summary

Item Description
Domain Domain in NSM in which the source IDP cluster is managed.
Name Name of the cluster.
Cluster ID Number uniquely identifying a cluster on a given Ethernet segment
(retrieved from all nodes)
Description
The number of times that the RTO was placed to Set.
The number of times that the RTO was placed to Lost Peer.
The number of times that the RTO was placed to Group Detach.
Copyright © 2010, Juniper Networks, Inc.