Promax PROWATCH Neo + Manual page 75

be also captured by a short press on the export key
Analyzer mode. Pressing short again on the export key it clears the
reference.
Start Zoom (this function must be previously enabled on Preferences ->

Tools): It automatically sets parameters from the Spectrum mode in order
to analize small signals. Settings are:
•Span: 200 kHz.
•Resolution filter: 12.5 kHz.
•Reference level: minimum.
•Measurement units: dBm.
NOTE: Some parameters such as average, spectrum line, tone level and marker
are recovered after switching on.
Advanced Menu in TV mode
►
Analogue Signal: This option is available only if the detected or selected

signal is ANALOGUE. Pressing the
for the analogue signal between antenna (via RF connector) and external
(via V/A input connector). To get an external analogue signal use the A/V
input.
Aspect Ratio: This option is available only if the detected or selected signal

is ANALOGUE. It allows the user to select the image aspect ratio (4:3;
16:9). It remembers this selection even after switch off.
Advanced: This option is available only if the detected or selected signal is

DIGITAL. There are these options:
•Audio: It allows the user to select among the audio tracks available.
•TS Data: It shows the IRG data descriptor. If the signal contains this
carrier identifier, this option will be enabled. If the signal does not contain
this identifier, the option will be disabled (for more information refer to
section "IRG descriptor").
•Discovered URLs: If shows the URL related to the interactive service.
March 2025
key it allows you to select the source
67
in the Spectrum
Chapter 4: RF SIGNAL TUNING