Advertisement
Operation in Remote Mode from a Local Network using webControl
►
1
Use a ethernet cable to connect the IPCTRL output to your data network.
2
The IP by default is 10.8.8.188
manual (for more details refer to
3
From a remote access device (PC, mobile device) connected to your LAN
network run a standard web browser (Chrome recommended).
4
On the address bar write the address to remotely access the equipment.
5
If the connection is successful, it should appear on screen the webControl
welcome screen (see figure). This screen shows the equipment model and
serial number.
*. IP by default is 10.0.6.198 for firmware versions prior to 26.8
March 2025
Figure 6. Local Mode Connection
*
. To change this IP follow instructions on this
7
"Setting / Updating" on page
9).
Chapter 2: SETTING UP
Advertisement
Need help?
Do you have a question about the PROWATCH Neo + and is the answer not in the manual?
Questions and answers