Promax PROWATCH Neo + Manual page 212

10 WEBCONTROL
10.1 Introduction
The webControl function allows you to connect remotely to the equipment in
order to visualize measurements and operate on it. The equipment must be
connected to a data network. To connect to equipment from a remote access
device you need just a standard web browser.
WebControl modes are:
Measurement and Spectrum: It shows spectrum and measurement from

the tuned channel.
TV Parameters: It shows data, video and audio from the tuned channel.

Console: It emulates a portable equipment and allows you to interact with

it in first person.
Quality Signal Monitoring: It monitors a signal according to some

parameters selected by the user.
Historical Monitoring: It shows data from monitoring and they can also be

exported.
Installations Management: It manages installation files and creates

channel plans.
Task Management: It allows the user to schedule some tasks.

There is also an option on demand:
Mask Monitoring

reference spectrum.
Next section explains how to configure the equipment to be able to connect
remotely. Following sections explain each mode.
*. Contact PROMAX if you want to buy this option.
Chapter 10: WEBCONTROL
*
: It monitors RF spectrum by comparing against a
webControl introduction
204
S
C
A
N
March 2025