Promax PROWATCH Neo + Manual page 195

7.4.1 PING/TRACE
The PING tool is a diagnostic tool about the network. To use it follow these steps:
1 Set parameters for the PING/TRACE test. Press on
are:
Mode: Select between

•PING: It confirms if a given unit can get any response from another
machine in the same network.
•TRACE: It shows all IP servers between the meter and the IP address
measuring transit delays of packets across the network.
•Avg Packet Delay / IPDV: It shows delay between two points in the
network and changes in this delay.
Pings for each IP (only for PING tool): Number of times to repeat the ping

test. If "Forever" is selected, it can be stopped with "Cancel" or "Exit".
Ping range (only for PING tool): Range of addresses to apply the ping test.

It adds the number selected to the original IP address.
2 Click on IP Address and enter the IP address of the remote machine you want
to check its communication. It works for both local network or external
network.
3 Press
of the remote machine.
March 2025
: Start. The equipment starts sending data packets to the IP address
Figure 121.
187
: Advanced. Options
Chapter 7: IPTV