Promax PROWATCH Neo + Manual page 260

8 Once SCD/EN50494 is configured, the user can select the slot by the
"Tuning" key.
11.6.3 SCD2 / EN50607 (JESS) Commands
Through the SCD2/EN50607 (internation standard, also known as JESS)
function is possible to control the devices of a TV satellite installation that are
compatible with this standard. This technology has two main functionalities: one
for configuring headends, and another for configuring sockets. This technology
requires bidirectional DiSEqC capabilities.
Thanks to its bidirectional DiSEqC capabilities, the meter can automatically read
the configuration from any SCD2/EN50607 compatible unit connected to it. In
case that no compatible device is detected, the meter allows the user to make
a blind configuration of the unit without any confirmation other than spectrum
reference.
For information about JESS technology, developed by JULTEC, refer to its
website (http://jultec.de/).
1 Connect the RF cable to the RF connector for the input signal of the
equipment.
2 Press the Spectrum key
3 Press the Settings key
Settings menu, select the polarization (horizontal/vertical) and the satellite
band (high/low).
4 If necessary, enable the Supply output and select the supply voltage for the
LNB.
NOTE: When tuning by channel is selected, polarization, satellite band and
supply output cannot be changed, because these parameters are
determined by the channel plan.
5 In the option SCD2/EN50607, select ON to enable it. It appears the JESS icon
at the top right corner of the screen.
6 Now the SCD2/EN50607 option shows a new menu. Select Configuration to
access the configuration parameters. The user can select the power, central
frequency, tone beacon and satellite for each band. The user can also select
the number of user bands and the available satellites through the option
"Configuration" on key
Chapter 11: CONNECTING TO EXTERNAL DEVICES
(key S) to access the spectrum analyzer mode.
(key C) and select the satellite band. From the
.
252 March 2025