Promax PROWATCH Neo + Manual page 213

10.2 Settings and Remote Access
General Configuration
►
1 There are two ways to configure the equipment:
•Connecting a pendrive with the STATE.xml file to the USB port. The
STATE.xml should contain configuration data (for more details refer to
"Change of Network Settings via PENDRIVE" on page
•By the user's interface. To access user's interface you need to connect in
local mode (for more details refer to
page 6). In the next section it is explained how to connect to a network
following this way.
► Connection Settings (Ethernet / WiFi) in Local Mode
Next following steps describe how to configure the equipment in local mode
(with a keyboard and a monitor) using the user's interface in order to connect
to a local data network.
1 The equipment can be connected to a data network via an Ethernet cable or
via WiFi. To access the configuration parameters:
•Ethernet network: Access the preferences options by pressing the
"Installations"
you can find the configuration parameters to register in the network.
•WiFi network: Connect the USB WiFi adapter and the WiFi configuration
window will appear or you can also access through the "WiFi configuration"
menu from the "Tools" button (F3).
2 Select DHCP ON, if you connect the equipment to a network with a router or
server with DHCP protocol enabled. Then the network will set automatically
the parameters in the equipment. If not, follow the next steps to set the
equipment.
3 On "IP Address" box enter the equipment's IP. Use an IP in the same range
used by your PC in the local network (if you do not know these data see "find
out local network data" section). For instance, if the IP for your PC is
10.0.1.18, the equipment must have a free IP in the same range, like
10.0.1.50.
NOTE: Another option is to keep default settings and change your PC IP to the
same range. As the IP by default is 10.8.8.188
IP on the same range, like 10.8.8.50.
IP by default is 10.0.6.198 for firmware versions prior to 26.8
*.
March 2025
key (key F) for 1 second. Go to the "Network" tab where
205
9).
"? Operation in Local Mode" on
*
the PC should have a free
Chapter 10: WEBCONTROL