Advertisement
3
Once selected, press
Operation
►
1
Connect the external LTE filter between the signal and the RF input.
2
Tune the channel that is possibly affected by a LTE interference.
3
Press the key
4
Select the LTE Ingress Test mode.
5
Screen shows a confirmation message. Press on
or
"No" if filter is not connected.
6
It starts to measure.
7
To change filter status (ON / OFF), press again the
confirmation message. Connect / disconnect the LTE filter at the RF input and
then press
8
The user can enable / disable the LTE measure by pressing the
OFF. Remember to connect / disconnect the LTE filter to the RF input. Each
time a LTE measure starts, the time counter will reset.
9
Check how to connect and disconnect the LTE filter affects the installation,
by comparing the MER measure and the LTE band power.
Chapter 5: TOOLS
to save changes and
: Tools.
key: Ok to start measuring.
92
to exit "Preferences".
"Yes" if filter is connected
key and will appear a
March 2025
: ON/
Advertisement
Need help?
Do you have a question about the PROWATCH Neo + and is the answer not in the manual?
Questions and answers