Promax PROWATCH Neo + Manual page 258

of switching protocols (13 to 18 V, 22 kHz) and meet the needs of the
installations for the reception of digital TV.
1 Connect the RF cable to the RF connector for the input signal of the
equipment.
2 Press the Spectrum key
3 Press the Settings key
4 From the Settings menu, select the polarization (horizontal/vertical) and
the satellite band (high/low).
5 If necessary, enable the Supply output and select the supply voltage for the
LNB.
NOTE: When tuning by channel is selected, polarization, satellite band and
supply output cannot be changed, because these parameters are
determined by the channel plan.
6 Select the option DiSEqC mode.
7 Two new functions appear on the softkeys: Command
DiSEqC programs appear classified in categories or folders.
8 Select the command or program and press Enter to send it to the antenna.
These commands or programs allow the user to control an antenna (for more
information about DiSEqC commands and programs download document
from PROMAX
11.6.2 SCD / EN50494 (SatCR) Commands
By means of function SCD/EN50494 (international standard, also known as
SatCR) it is possible to control the devices of a TV satellite installation that are
compatible with this standard, which allows to concentrate downlink frequencies
(slots) by an only cable. By this way each user using a slot can tune and decode
any signal present in the satellite.
1 Connect the RF cable to the RF connector for the input signal of the
equipment.
2 Press the Spectrum key
3 Press the Settings key
Chapter 11: CONNECTING TO EXTERNAL DEVICES
(key S) to access the spectrum analyzer mode.
(key C) and select the satellite band.
website).
How to align a dish via DiSEqC
(key S) to access the Spectrum analyzer mode.
(key C) and select the satellite band.
250
and Software .
S
C
A
N
March 2025