Promax PROWATCH Neo + Manual page 52

When this option is enabled the equipment applies at the output the voltage
selected by the user in the Supply Voltage option (see below). When this option
is disabled the equipment does not apply the voltage to the output but it will
behave as if it did.
Supply voltages (available for terrestrial and satellite band)
►
It selects the voltage to be applied to an external unit. Available voltage options
change depending on the selected band. In tuning by channel mode this option
can not be changed because is defined by the channel.
Voltage available for terrestrial band: External, 5 V, 12 V and 24 V.

Voltage available for satellite band: External, 5 V (for devices working with

5 V such as GPS active antennas), 13 V, 13 V + 22 kHz, 15V, 18 V, 18 V +
22 kHz.
In the External supply voltage option the power supplier to the external units is
the power supplier of the antenna preamplifiers (terrestrial television) or the
satellite TV receiver (collective or domestic).
LNB Drain (available for terrestrial and satellite band)
►
The LNB drain option shows the voltage and current flowing to the external unit.
If there is any problems (e.g. short circuit), an error message appears on the
screen ('SHORTCIRCUIT'), a warning beep sounds. The equipment allows you to
disable the output tension that feeds the LNB when the short-circuit warning is
displayed.
The equipment does not return to its normal operating state until the problem
is solved. During this time the equipment checks every three seconds if there
still the problem, warning with an audible signal.
DiSEqC Mode (only available for satellite band)
►
It enables or disables DiSEqC mode. DiSEqC (Digital Satellite Equipment
Control) is a communication protocol between the satellite receiver and
accessories of the satellite system (for more details refer to
Commands" on page
Chapter 3: SETTINGS AND PREFERENCES
249).
44
"DiSEqC
March 2025