Promax PROWATCH Neo + Manual page 319

For more details refer to
iii.5 Basic DAB operation
1 Connect the RF input signal to the equipment.
2 Select RF source signal and terrestrial band in Settings
3 Select the channel plan and the channel or the frequency where the DAB/
DAB+ signal is located. Frequencies with three decimals must be entered
using the virtual numeric keypad that will appear when editing the current
frequency.
4 To enable auto-detection for DAB/DAB+, access "Preferences" pressing the
key
Now press F2 to confirm that the Stealth-ID option is ON.
5 When the DAB signal is locked, the status bar will turn green.
6 For more details refer to
iii.6 Operation Modes
The information that appears on screens for each mode (Measurement mode,
Spectrum mode and TV mode) is described below. To change the mode, press
the corresponding mode key. To change the screen in the same mode, press the
same mode key consecutively.
iii.6.1 Measurement Mode
Cursor functions:

•Up/down: Change of main measurement on screen (only for Measurement
1/3).
•Right/left: Change of channel/frequency.
Function Keys:

•F1 Tuning: Tuning options.
•F2 DAB: DAB detected parameters.
•F3 Tools: Tools enabled for DAB.
Status Bar: It shows if the ETI is locked or unlocked. If it is locked then it

shows the TII (Transmitter Identification Information) that is received with
more power. It also shows the transmitter main identifier (M) and sub-
identifier (S).
March 2025
"WEBCONTROL" on page 204.
(key F) for one second and in the StealthID tab select the DAB option.
"RF SIGNAL TUNING" on page
311 Annex iii: ADVANCED FM OPTION+ BASIC DAB
(key S).
57.