Adrv9001 Evaluation System; Connection For External Device Clock Initial Setup; Hardware Kit - Analog Devices ADRV9005 Reference Manual

Reference Manual

ADRV9001 EVALUATION SYSTEM

The ADRV9001 family demonstration system evaluates the device without having to develop custom software or hardware. The system
comprises a radio daughtercard, a Xilinx ZYNQ ZC706 or ZCU102 motherboard, an SD card with operating system, a 12 V power supply for
the ZYNQ ZC706 or ZCU102 that connects to a wall outlet, and a C#-based evaluation software application. The evaluation system uses an
Ethernet interface to communicate with the PC.
INITIAL SETUP
The ADRV9001 transceiver evaluation software (TES) is the GUI to communicate with the evaluation platform. It can run with or without the
evaluation hardware. When the TES runs without the hardware, configure it fully for a particular operating mode for demonstration. If the
evaluation hardware is connected, set up the desired operating parameters with the TES, and then the software can program the evaluation
hardware. After the device is configured, use the evaluation software to transmit waveforms using custom waveform files as well as observe
signals received on one of the receiver input ports. The TES can be used to generate and execute an initialization sequence in the form of an
IronPython script.

HARDWARE KIT

The ADRV9001 demonstration kit contains the following:
The customer evaluation (CE) board as a daughter card with FPGA mezzanine card (FMC) connector.
►
One SD card containing the image of the Linux operating system with the required evaluation software.
►
The SD card type is 16 GB size, type 10.
►
Requirements
The hardware and software require the following:
The ADRV9001 demonstration system kit.
►
A Xilinx ZC706 ZYNQ (EK-Z7-ZC706) or ZCU102 evaluation platform (the ADRV9001 demonstration kit does not include the Xilinx
►
platforms)*.
One 12 V power supply to power the Xilinx platform.
►
®
Microsoft Windows 7 (×86 and ×64) or Windows 10 (×86 and ×64) operating system on the controlling PC
►
The PC must have a free Ethernet port with the following constraints:
►
If the Ethernet port is occupied by another LAN connection, use a USB-to-Ethernet adapter.
►
The PC must be able to access the following ports over this dedicated Ethernet connection:
►
22 (SSH protocol)
►
55557 (access to the evaluation software on the Xilinx platform).
►
TES (contact an Analog Devices representative for access to this software).
►
The user must have administrative privileges.
►
SD Card Imaging
To image the SD card properly for use in the Xilinx platform, download the ADRV9001 Disk Imaging Utility and the dotNet Disk Imager. Find
®
these on the EngineerZone support forum for the
when writing to an SD card that prevents the FPGA from reading the card.
Hardware Setup (ZYNQ ZC706)
The Xilinx ZYNQ ZC706 platform setup requires the following steps:
1. All jumpers are in the positions shown in
2. SW11 is in position, as shown in
3. Place the SD card included with the evaluation kit in the J3 slot of the ZYNQ platform.
Figure 310 shows the evaluation hardware setup.
*All variants of the ZC706 evaluation kit are suitable to demonstrate the performance of the ADRV9001. Analog Devices does not guarantee
that all future versions and derivatives of the ZC706 will work with the ADRV9001 daughter card and ADRV9001 TES to demonstrate
analog.com
TES GUI & Software
Figure 308.
Figure 308 (1, 2, 5 = A position).
Support. Follow the instructions and check if there is any encryption
ADRV9001
Rev. A | 329 of 377