Temporarily Disabling The Signaling (Monitor) - Kenwood NXR-1700 Function Reference

Hide thumbs Also See for NXR-1700:
Table of Contents

Advertisement

6 ANALOG COMMUNICATIONS / 6.5 Temporarily Disabling the Signaling (Monitor)

Temporarily Disabling the Signaling (Monitor)

6.5
Monitor is the function to unmute the speaker if the level of the received signal is high, even if the received signaling
(the QT tone, DQT code or RAN code) does not match the signaling preconfigured for the repeater (the QT tone,
DQT code or RAN code). This function can be used to check in advance whether or not a channel to be used for
transmission is already being used by other groups.
Monitor can be changed from enabled and disabled by using the Remote Control function of the Web Tool and by the
Knob operation.
An icon is displayed on the OLED display while Monitor is in the enabled state.
The following are the repeater behaviors that may vary depending on the configuration in Channel Type.
(Refer to
Configuring the Reception Method of a Channel (Channel
Channel Type
Analog
DMR
NXDN
Mixed
Note
When the repeater is operated in the repeater mode, even if Monitor is enabled, the repeater does not transmit using the
Repeat PTT control unless the received signaling (the QT tone or DQT code) matches the signaling preconfigured for the
repeater (the QT tone or DQT code).
FUNC (E)/ Ver 2.00
Table 6-2 Configuration of Channel Type (Monitor is Enabled)
Description
Disables the signaling decode by the QT tone or DQT code and unmutes the speaker
just by receiving a carrier.
Disables the signaling decoding by the RAN code and unmutes the speaker just by
detecting an NXDN frame. The repeater does not unmute the speaker just by receiving a
carrier.
Disables the signaling decode by the QT tone or DQT code. If an analog signal is
received, the speaker is unmuted just by receiving a carrier.
Type).)
104

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nxr-1800Nxr-1700eNxr-1800eNxr-1800e2

Table of Contents