7 DMR DIGITAL COMMUNICATIONS / 7.5 Continuing Transmission for a Certain Length of Time After Various
Transmissions End
Note
・
This function works on a channel with "DMR" configured in Channel Type. (Refer to
Channel (Channel
Type).)
While the Channel Hangtime (DMR Channel) is counting down, the repeater does not start repeat transmission even if the
・
repeater receives an analog signal.
If both Call Hangtime and Channel Hangtime (DMR Channel) are configured in the repeater, the countdown of the Channel
・
Hangtime (DMR Channel) starts after the countdown of the Call Hangtime ends.
If Data Hangtime is configured in the repeater, the countdown of the Channel Hangtime (DMR Channel) starts after the Data
・
Hangtime ends.
・
If the countdown of the Channel Hangtime (DMR Channel) or Channel Hangtime (Mixed Channel) is extremely shortened,
the DMR digital communication required for repeat transmission may not function properly.
If "TA Direct" is configured in Operation Mode, Channel Hangtime (DMR Channel) is not activated.
This function works during transmission by any PTT (Repeat PTT/ Network PTT/ Console PTT/ External PTT/ SIP PTT/ Test
PTT).
Configuration using KPG-D7
Configuring Channel Hangtime (DMR Channel) ( Edit > Optional Features > Common Page 1 > Repeater/
・
External/ Network/ Console PTT > Channel Hangtime (DMR Channel))
Configuration using Web Tool
Configuring Channel Hangtime Enable/Disable ( Maintenance > Remote Control > Channel Hangtime > Enable
・
/ Disable)
FUNC (E)/ Ver 2.00
Configuring the Reception Method of a
116