12 CONVENTIONAL IP NETWORK / 12.8 IP Remote Control Interface (IPRCI)
The transmission behavior of Unit ID Output is the same behavior in Operation Mode for which a Console can be
used.
In DMR Mode, the match of the received CC is the required condition for the behavior of Unit ID Output.
In NXDN Mode, the match of the received RAN is the required condition for the behavior of Unit ID Output.
In Analog Mode, the match of the received QT/DQT is the required condition for the behavior of Unit ID Output.
Note
In a single transmission operation, a UID may be output more than once depending on the reception status of the
・
receiver.
・
The timing to output the UID is when the frame is synchronized. Therefore, even if a single Call operation is
performed, a UID may be output more than once if the synchronization is lost and then established.
J Command Output
J Command Output is the function to notify the status change by an IPRCI command when the repeater status such as
the enabling or disabling of a PTT function and the RSSI level changes.
Configuration
J Command Output
The IPRCI command indicating the status change (such as J Command) is sent to the IPRCI Console when the
repeater status changes.
If J Command Output is enabled, the status change is sent to the IPRCI Console by an IPRCI command when the
change of the repeater status such as the enabling or disabling of a PTT function and the RSSI level occurs.
If J Command Output is disabled, the IPRCI command is sent to the IPRCI Console when a command output request
is made from the IPRCI Console.
Configuration using KPG-D7
Configuring Unit ID Output to be enabled or disabled ( Edit > Optional Features > Common Page 3 > IP Remote
・
Control Interface (IPRCI) > IPRCI Output > Unit ID Output)
Configuring J Command Output to be enabled or disabled ( Edit > Optional Features > Common Page 3 > IP
・
Remote Control Interface (IPRCI) > IPRCI Output > J Command Output)
FUNC (E)/ Ver 2.00
Table 12-21 J Command Output
Description
J Command Output is configured to be enabled or disabled for digital mode and analog
mode.
182