Factory Reset - Kenwood NXR-1700 Function Reference

3 BASIC OPERATION / 3.7 Factory Reset

Factory Reset

3.7
The values of general configurations stored in the repeater, the Log information stored by the maintenance function, and
the area used for data storage by the Field Support function (Web Tool) can be restored to the factory default state.
Perform this operation if a User Name or User Password of the Administrator (Web Tool) or the Access Key of the Multi
Loader has been lost, or if an IP Address of the repeater has been forgotten.
The following is the procedure to migrate to Factory Reset:
1. With the 6 pin and 7 pin (DG) of the I/O Interface (D-Sub 25-pin) connected, connect to the external power supply.
If Power Control is disabled, proceed to step 3 since step 2 is not required.
Press the Knob if Power Control is enabled. The Knob does not need to be continuously pressed at this time.
2.
Press the Knob (again if step 2 is executed) after the ■■ indication is confirmed on the OLED display, and
3.
continue pressing until the ■■■ indication is displayed. When the ■■■ indication is displayed, stop pressing the
Knob to migrate to the Factory Reset screen. If the ■■■■ indication is displayed without migrating to the Factory
Reset screen, migrating to the Factory Reset screen procedure is not done correctly, so start again from step 1.
Pressing the Knob in the Factory Reset screen displays Cancel at the upper part and Execute at the lower part,
4.
and the action for Factory Reset can be selected. To execute Factory Reset, rotate the Knob to select Execute
and press the Knob.
The Knob operation in step 4 needs to be performed within 5 seconds. If the operation is not executed within 5 seconds,
the process migrates to Level 3 of Startup Status, and the process of migrating to User Mode continues.
The repeater is initialized to the factory default if Factory Reset is executed.
In the factory default, "Unprogrammed" is displayed and the following operations can be performed:
Operation
FPU Data Read
FPU Test Mode
FPU Data Write
FPU Repeater Information
Embedded Message with Password Read
Embedded Message with Password Write
FUNC (E)/ Ver 2.00
Table 3-2 Items Available for Operation in the Factory Default
Action
The FPU data as the factory default is read from the repeater.
The repeater can enter Test Mode in the FPU.
The FPU data of the repeater can be updated.
The repeater information in the FPU can be acquired.
An Embedded Message is read with no data (blank).
An Embedded Message can be stored without a password because
the password is initialized.
77