Kenwood NXR-1700 Function Reference page 62

2 GETTING STARTED / 2.4 System Structure
Table 2-8 Supported Transmission of Conventional IP Network (Receiver TKR-Dx10 Series)
Sender
TKR-Dx10
NXR-1700/ NXR-
1800
*1 If NXR-1700/ NXR-1800 is used in a system structured with TKR-Dx10 series, NXR-1700/ NXR-1800 needs be
programmed to match the functions of the TKR-Dx10 series.
Note
Repeater programming needs to be done by using the FPU dedicated to the repeater.
・
NXR-1700/ NXR-1800 is not supported for the coexistence of DMR Mode and NXDN Mode.
・
Configuration using KPG-D7
Configuring Product Information ( Model > Product Information)
・
NXDN Mode
Refer to the link about NXDN Mode.
IP Interface Function
To allow the repeater to communicate with the Console, Voice Logger, and SIP Phone Server, IP Interface
needs to be enabled. If IP Interface is enabled in Product Information in the FPU, the IP Interface function can be
used.
The IP Interface function allows AIS communication and NXIP communication for the Console in each of DMR Mode
and NXDN Mode. Also, the VLI communication and SIP Phone function of each mode are supported The IP Interface
Protocol communication can be executed also if Analog Mode and Analog channels are configured. The behavior in
the following table is applied. Also, the repeater operation by an IPRCI command defined in IP Interface Protocol used
by a Console is supported as well.
Operation Mode
DMR Mode
FUNC (E)/ Ver 2.00
Receiver
Ch Type DMR
DMR Frame
Analog Frame
DMR Frame
Analog Frame
Table 2-9 IP Interface Function
Signaling
DMR Tier2
Analog
DMR Tier2
Analog
DMR Tier2
Analog
TKR-Dx10
Ch Type Mixed
✔ ✔
✔ *1 ✔ *1
－ *1
Application
Console
Voice Logger
SIP Phone
61
Ch Type Analog
－
－
*1
IP Interface Protocol
AIS
AIS
AIS Based RTP
AIS Based RTP
SIP
Not supported