Kenwood NXR-1700 Function Reference page 187

13 MANAGING DEVICES ON AN IP NETWORK (SNMP) / 13.1 SNMP
Configuration
SNMP Interface
Community Name
Trap Destination
Address
Trap Event (General)
Trap Event (Hardware)
FUNC (E)/ Ver 2.00
Table 13-2 SNMP
Description
Configures the SNMP function to be enabled or disabled.
If SNMP Interface is enabled, the repeater responds to Polling. Also, the repeater
performs the Trap notification.
If SNMP Interface is disabled, the repeater does not respond to Polling. Also, the
repeater does not perform the Trap notification.
Configures the name of the network range to be monitored by SNMP.
Community Name is used as the password for information acquisition by SNMP.
When the Community Name added to an SNMP request matches Community Name
configured for the repeater, the repeater behaves according to the request.
Configures the SNMP trap destination address (IP Address or Name).
The repeater notifies the configured Trap Destination IP Address of the SNMP trap
when a failure value occurs or the status changes.
Configures whether to notify a Trap for each category of the General genre (Status,
Control, Warning, Error).
Among the categories shown in Genre 2 of Table "Supported Items for the KENWOOD
Proprietary MIB and the Combination of Information Notification Methods (Response,
Trap)", the enabled control items (Trap column: Y) are notified as a Trap.
Configures whether to notify a Trap for each category of the Hardware genre (Common,
Voltage, PLL, Consumption, Temperature, AUX Port).
Among the categories shown in Genre 2 of Table "Supported Items for the KENWOOD
Proprietary MIB and the Combination of Information Notification Methods (Response,
Trap)", the enabled control items (Trap column: Y) are notified as a Trap.
186