Kenwood NXR-1700 Function Reference page 196

14 IP INTERFACE FUNCTION / 14.2 Voice Logging
Voice Logger List
In Voice Logger List, a list of configured Voice Logger can be confirmed and each Voice Logger can be edited.
Configuration
Voice Logger ID
Valid
IP Address
Port
Port(Max)
Read Only
FUNC (E)/ Ver 2.00
Table 14-3 Voice Logging List
Description
A management number of Voice Logger configured in Voice Logger List can be confirmed.
Voice Logger ID is handled as the reference value for the Default Voice Logger ID and
Voice Logger ID of the Target GID, Target UID, and Target SIP Phone ID.
Valid is the function to enable and disable the use of Voice Logger.
By disabling Valid to temporarily stop the use of Voice Logger, the temporary stop can be
done without deleting the configuration in Voice Logger. If Valid is enabled, a voice call
can be recorded by sending the audio packet to Voice Logger.
ON
Permits transmission to the target Voice Logger.
OFF
Prohibits transmission to the target Voice Logger.
An IP address of Voice Logger is configured.
An audio packet is sent to Voice Logger with the value configured in IP Address as the
destination IP address.
IP Address can be redundantly configured in Voice Logger List. This allows the same
Voice Logger to be used depending on the port.
The lowest value for the receive port number of Voice Logger is configured.
An audio packet is sent to Voice Logger with the value configured in Port as the
destination port number.
A redundant value can be configured in Port.
An audio packet is sent to Voice Logger by using a single port for 1 voice call within the
range from Port to Port (Max) as the receive port of Voice Logger.
The highest value for the receive port number of Voice Logger is displayed.
An audio packet is sent to Voice Logger by using the range from Port to Port (Max) as the
destination port number.
The port number displayed in Port (Max) is the highest value assigned as the receive port
of Voice Logger.
A port number indicated by the range from Port to Port (Max) is individually used for each
single voice call, and the port number being used becomes available when the call ends.
The value in Port (Max) is automatically calculated from the value configured in Maximum
Number of Talk Path with the port number configured in Port as the base.
195