Kenwood NXR-1700 Function Reference page 154

12 CONVENTIONAL IP NETWORK / 12.1 Communicating with a Repeater Connected by Using an IP Network
(Intersite Call)
Network-wide Signaling
Network-wide Signaling is the function to determine the behavior of the repeater which receives an Intersite Call when
the repeater transmits using the Network PTT control.
According to the configuration in Network-wide Signaling, the repeater which receives an Intersite Call behaves as
follows:
Configuration Description
Caller Site The repeater which receives an Intersite Call transmits the received signal using the
Network PTT control by using the Signaling Encode that is same code as the Signaling
Encode used by the transmitting repeater.
The Signaling Encode can be changed for each call; hence the group can be distinguished
by the Signaling Encode while the same channel is shared among several groups.
Site Dependent The repeater which receives an Intersite Call transmits using the Signaling Encode
configured for each repeater.
If Multiple Encode/Decode Table is configured, the repeater transmits using the Signaling
Encode configured in Multiple Encode/Decode Table. If the received Signaling Encode
matches the Signaling Encode preconfigured in Multiple Encode/Decode Table, the
repeater transmits the received signal by using the Network PTT control.
If Multiple Encode/Decode Table is not configured, the repeater transmits by using the
Signaling Encode (Primary) configured for the channel. In this case, the repeater transmits
the received signal by using the Network PTT control, regardless of whether the received
Signaling Encode matches the Signaling Encode (Primary) configured for the channel.
If the repeaters sharing the same frequency are adjacent and the Signaling Encode is used
for distinction, and if the Signaling Encode used for transmission is determined as license
conditions for frequency, this configuration is used.
Note
Configure "Site Dependent" in Network-wide Signaling to restrict the delivery range of an Intersite Call for each
・
GID or UID by using User List.
・ In the system where the TKR-Dx10 series coexists, only the operation with "Multiple Encode/Decode Table"
disabled in the configuration of Site Dependent is possible.
The repeater behaves only as Site Dependent on a DMR channel.
・
Configuration using KPG-D7
Configuring Network-wide Signaling ( Edit > Conventional IP Network > Intersite Call > General > Network-wide
・
Signaling)
FUNC (E)/ Ver 2.00
Table 12-2 Network-wide Signaling
153