Kenwood NXR-1700 Function Reference page 144

10 FUNCTION PORTS / 10.3 Available Functions for AUX Output Ports
Function Name
TXS
RF Power Down Detection
VSWR Error Detection
Hot Standby LAN Error
AUX Output Control
None
Note
By activating Squelch Off, the COR port does not become active unless the repeater is receiving a signal even if
・
the RX1 LED lights.
Even if the repeater unmutes the speaker by activating Monitor On, if a signaling is configured, the TOR port
・
does not become active until the received signaling matches the one preconfigured for the repeater.
Configuration using KPG-D7
Assigning functions to the AUX Output port ( Edit > Function Port > AUX > AUX Output)
・
Configuring the threshold for RF Power Down Detection ( Program > Test Mode > Tuning Item > RF Power
・
Down Detection)
FUNC (E)/ Ver 2.00
Description
The output port becomes active when the repeater
transmits.
The output port becomes inactive if the repeater exits
transmit mode.
The output port becomes active if the transmission
power is reduced.
The output port becomes inactive if the transmission
power is increased.
The output port becomes active if the strength level of
the reflected wave is greater than the threshold value
while the repeater is transmitting.
The output port becomes inactive if the strength level of
the reflected wave is lower than the threshold value
while the repeater is transmitting.
The AUX Output port becomes active if the Hot Standby
LAN Connection Error occurs during the Hot Standby
operation. The AUX Output port becomes inactive if the
error state is reset.
The status of the output port can be controlled by using
the Remote Control function of the Web Tool.
If "ON" is configured in AUX Output Control of the
Remote Control function by using the Web Tool, the port
is activated according to the configuration in Logic Type
(Active High or Active Low).
No function is activated.
143
Remarks