2 GETTING STARTED / 2.4 System Structure
Repeater failure (Sub Repeater)
Status: Main Repeater (Active)/ Sub Repeater (Standby)
If a Sub Repeater fails for any reason and is replaced, a Main Repeater cannot synchronize with the Sub Repeater.
In this case, a Main Repeater migrates to Failsoft Mode.
Figure 2-12 Repeater (Sub) Failure
Repeater (Sub Repeater) recovery precautions
Remove the failed Sub Repeater and perform the recovery procedure.
The configuration of a Sub Repeater to be replaced needs be the same as the one prior to replacement, and Write needs
to be performed beforehand.
Figure 2-13 Repeater (Sub) Recovery
72
FUNC (E)/ Ver 2.00