2 GETTING STARTED / 2.2 Writing the Configuration Data to the Repeater
Hot Standby needs to be enabled to use the redundancy function by a Main Repeater and a Sub Repeater. If Hot
Standby is enabled, configure Hot Standby Mode for a Main Repeater or Sub Repeater, and configure a Virtual IP
Address for either case.
Table 2-2 Action Category for a Physical IP Address and a Virtual IP Address When Hot Standby Is Enabled
Action
Web Tool
FPU
IP Conventional
VLI
IPRCI
NXIP
AIS
SIP Phone
SNMP
Hot Standby Communication
Multi Loader
Note
The IP address configured for the repeater main unit via the Web Tool is an item for Read Only in the FPU data.
・
To use the Hot Standby function, the Virtual IP Address to be configured for a Main Repeater and for a Sub Repeater
・
needs to be identical.
FUNC (E)/ Ver 2.00
PIP (Physical IP Address)
✔
✔
-
-
-
-
-
-
✔
✔
✔
55
VIP (Virtual IP Address)
-
-
✔
✔
✔
✔
✔
✔
-
-
-