Mode; Writing And Reading Configuration Data (Fpu Programming Mode); Overwriting Firmware (Firmware Programming Mode) - Kenwood NXR-1700 Function Reference

17 MODE / 17.1 Writing and Reading Configuration Data (FPU Programming Mode)

17 MODE

The repeater has several modes: a mode for writing the configuration data to the repeater, a mode for reading the
configuration data from the repeater to KPG-D7, a mode for updating the firmware, and a mode for testing transmit
and receive characteristics of the repeater.

17.1 Writing and Reading Configuration Data (FPU Programming Mode)

FPU Programming Mode is the mode to write the configuration data configured by using KPG-D7 to the repeater or to
read the configuration data configured for the repeater to KPG-D7.
Note
 When writing the configuration data to the repeater ends, the repeater restarts operations and starts the behavior of the written
configuration data.

Refer to the help texts attached to KPG-D7 for the operation in FPU Programming Mode.

17.2 Overwriting Firmware (Firmware Programming Mode)

Firmware Programming Mode is the mode to write the firmware to the repeater.
When the firmware rewriting completes, the repeater restarts.
Via the network
By accessing the Web Tool from a Web browser, the firmware can be written to the repeater via the network. During
the firmware writing, "Firm Updating" is displayed on the OLED display. The IP address to be accessed is the unique
IP address of the repeater. In addition, during the firmware rewriting, the repeater behavior is stopped. When the
firmware rewriting completes, "Shutting down" is displayed on the OLED display, and the repeater initiates restart.
Also, during the firmware rewriting, the repeater can be turned off by pressing and holding the Knob for 3 sec. In
addition, the firmware rewriting can be prohibited by using the Remote Access Control configuration.
Multi Loader
Multi Loader is the PC application to register multiple repeaters and rewrite the firmware in order. Because Firmware
Update for only the single connected repeater is supported by the Web Tool, Multi Loader is used for the use that
supports Firmware Update of an entire system.
FUNC (E)/ Ver 2.00
205