Kenwood NXR-1700 Function Reference page 108

6 ANALOG COMMUNICATIONS / 6.7 Using the Network by Using an Analog GID
Note
・ To output Analog audio to a Console, a valid Console configuration needs to be preconfigured in Console List.
To record an Analog voice call in Voice Logger, configure as the Target GID a Group ID configured in Analog GID.
・
An Analog GID can be configured regardless of Operation Mode.
・
Operate with a common awareness of the Analog GID between the repeater system administrator and Console
・
users.
 In DMR Mode, if an analog signal is delivered to another repeater in a Conventional IP Network, the fixed value
0xFFFDFF is output as the Destination ID and Own ID is output as the Source ID without the use of an Analog
GID.
 In NXDN Mode, if an analog signal is delivered to another repeater in a Conventional IP Network, the fixed value
0xFFF9 is output as the Destination ID and Own ID is output as the Source ID without the use of an Analog GID.
The communication for which the repeater receives a DMR or NXDN carrier and uses the same Group ID as an

Analog GID is distributed to each repeater according to the configuration in Console and User List.
 If a DMR or NXDN carrier is received on an Analog channel with QT/DQT not configured, audio packets are
output to the network in the same way as when an Analog carrier is received. However, the audio cannot be
played back by a Console because a digital signal is received as an analog signal.
FUNC (E)/ Ver 2.00
107