Kenwood NXR-1700 Function Reference page 151

12 CONVENTIONAL IP NETWORK / 12.1 Communicating with a Repeater Connected by Using an IP Network
(Intersite Call)
Behavior of the Receiving Repeater (Intersite Call)
The repeater, which receives an Intersite Call from the repeater that is interconnected by using an IP network, sends
the received signal by using the Network PTT control according to the configuration in PTT Priority. If the repeater
receives Intersite Calls from multiple repeaters, the repeater sends the first received signal using the Network PTT
control.
If the repeater receives an Intersite Call, the repeater sends the received signal by using the Network PTT control, by
using the Color Code configured in the repeater. Also, according to the configuration in User List, the repeater can
determine whether to send the received signal by using the Network PTT control.
Note
If Repeat Disable is enabled, the repeater cannot transmit using the Network PTT control, Console PTT control or SIP PTT
・
control. (Refer to Toggling Repeat Behaviors Between Enabled and Disabled (Repeat
 The signaling that supports an Intersite Call by analog communication is QT/DQT only. Therefore, a signaling of FleetSync,
etc. cannot be used for an Intersite Call.
IP Casting
IP Casting is the communication method used by the repeater to send and receive an Intersite Call by using the
Conventional IP Network function.
According to the configuration for IP Casting, the repeater behaves as follows:
Configuration
Unicast
Multicast
FUNC (E)/ Ver 2.00
Table 12-1 IP Casting
Description
The repeater uses the Unicast communications when the repeater transmits and
receives an Intersite Call by using the Conventional IP Network function.
Unicast is the communication method to send packet data to one site. If there are
multiple target sites, the same packet data is sent for multiple times.
In order to use this communication method, the target site needs to be configured in
Unicast Site List by using KPG-D7.
The repeater uses the Multicast communications when the repeater transmits and
receives an Intersite Call by using the Conventional IP Network function.
Multicast is the communication method to send packet data to multiple sites. Even if
there are multiple target sites, the same packet data is delivered to each site if packet
data is sent for once.
In order to use this communication method, the target IP address needs to be configured
in Multicast IP Address by using KPG-D7.
The transmitting repeater sends packet data to this Multicast IP Address when the
repeater makes an Intersite Call by using the Multicast communications. The receiving
repeater sends the received packet data by using the Network PTT control after
receiving the packet data sent to the Multicast IP Address when the receiving repeater
receives an Intersite Call.
Enable/Disable).)
150