Kenwood NXR-1700 Function Reference page 65

2 GETTING STARTED / 2.4 System Structure
For details, refer to the status migration diagram below:
Figure 2-4 Status Migration Diagram
During Switchover, only the Virtual IP Address is taken over to another repeater.
The following data are not taken over:
・Configuration data
・Logs
・Registration information of Console (if the IP Interface function is enabled)
The Active state can be forcibly migrated by using the Auto Active Status Switch function or Active Status Switch
function by Remote Control only when synchronization is established. Active Status Switch by Remote Control is the
function supported only by a Main Repeater.
The following are the cases where the status is switched to the Standby state by firmware during the Active state.
When a Main Repeater migrates to the Standby state under the following conditions, a Sub Repeater can enter the
Active state while synchronization is established.
64
FUNC (E)/ Ver 2.00