Kenwood NXR-1700 Function Reference page 140

10 FUNCTION PORTS / 10.2 Available Functions for the AUX Input Ports
Function Name
Repeat Enable
Reset
TX Disable
TX Enable
Voting Tone On
Voting Tone Off
AUX Input Monitor
Channel 1 to Channel
32
FUNC (E)/ Ver 2.00
Description
Enables the capability to transmit the received signal
by using the Repeat PTT control.
The trigger is detected on the Level of the signal
input to the AUX Input port.
The AUX Input port enters the "Repeat Disable" state
when the status of the port goes high level.
The software reset of the repeater is done when Low
Level is detected for the port.
The repeater returns to the same state as when the
repeater is turned on.
Disables all transmissions.
The trigger is detected on the Level of the signal
input to the AUX Input port.
The AUX Input port enters the "TX Enable" state when
the status of the port goes high level.
Enables all transmissions.
The trigger is detected on the Level of the signal
input to the AUX Input port.
The AUX Input port enters the "TX Disable" state when
the status of the port goes high level.
Enables Voting Pilot Tone.
The trigger is detected on the Level of the signal
input to the AUX Input port.
The AUX Input port enters the "Voting Tone Off" state
when the status of the port goes high level.
Disables Voting Pilot Tone.
The trigger is detected on the Level of the signal
input to the AUX Input port.
The AUX Input port enters the "Voting Tone On" state
when the status of the port goes high level.
The status of the port can be monitored by using the
Web Tool, etc.
This function can be used to monitor the status of a
signal input, etc. by connecting to an external device.
The current channel of the repeater is changed to the
specified channel when the low level is detected for
the port. The channel of the repeater is not restored
to the previous channel even if the port returns to
high level.
139
Remarks
Refer to Toggling Repeat Behaviors
Between Enabled and Disabled
(Repeat Enable/Disable).
Refer to Executing Software Reset of
the Repeater (Reset).
Refer to Toggling All Transmissions
by Using PTT Controls Between
Enabled and Disabled (TX
Enable/Disable).
Refer to Toggling All Transmissions
by Using PTT Controls Between
Enabled
and Disabled (TX Enable/Disable).