Kenwood NXR-1700 Function Reference page 190

13 MANAGING DEVICES ON AN IP NETWORK (SNMP) / 13.2 SNMP Troubleshooting
The following table (proprietary MIB Trap) describes the KENWOOD proprietary MIB:
OID (Object Identifier)
1.3.6.1.4.1.46861.1.1.1.3.1.2
1.3.6.1.4.1.46861.1.1.1.3.2.2
1.3.6.1.4.1.46861.1.1.1.4.1.2
1.3.6.1.4.1.46861.1.1.1.4.2.2
1.3.6.1.4.1.46861.1.1.1.4.3.2
1.3.6.1.4.1.46861.1.1.1.4.4.2
1.3.6.1.4.1.46861.1.1.1.4.5.2
1.3.6.1.4.1.46861.1.1.1.4.6.2
FUNC (E)/ Ver 2.00
Table 13-4 KENWOOD Proprietary MIB
Name Description
Hot Standby LAN Is output when the
Connection connection between the
Main Repeater and Sub
Repeater is disconnected in
Hot Standby.
Beacon Sync Is output when the Beacon
Member cannot receive a
Beacon synchronization
signal from the Beacon
Master.
Unprogrammed Is output when none of the
channels have been
configured.
USB Over Current Is output when an
overcurrent occurs in the
connected USB device.
TX Frequency Data Is output when the
Blank transmission is to be
performed on the channel
for which a transmit
frequency is not configured.
ESN Blank Is output when the ESN is
not written.
Feature Error Is output when the software
option function with no
license authentication is
enabled in the FPU
configuration.
Force Firmware Is output when the writing
Programming Mode of firmware fails and startup
occurs by using the old
firmware.
189
Trouble Shooting
Confirm the connection
status between the Main
Repeater and Sub
Repeater.
Confirm the connection
status between the Beacon
Member and Beacon
Master.
Configure the channel data
by using the FPU.
Disconnect the connected
USB device and execute
USB Port Recovery.
Configure a transmit
frequency by using the
FPU.
If this problem occurs,
contact JVCKENWOOD
sales company technical
staff.
Apply the required license
or disable the software
option function with no
license authentication.
Execute the writing of
firmware in order to start up
with Forced Firmware
Programming Mode.