Continuing Transmission For A Certain Length Of Time After Reception Stops (Repeater Hold Time); Temporarily Disabling The Squelch (Squelch Off) - Kenwood NXR-1700 Function Reference

6 ANALOG COMMUNICATIONS / 6.2 Continuing Transmission for a Certain Length of Time After Reception Stops
(Repeater Hold Time)
Continuing Transmission for a Certain Length of Time After Reception Stops
6.2
(Repeater Hold Time)
Repeater Hold Time is the length of time from when reception stops until the repeater terminates transmission using
the PTT control (Repeat/ Network/ Console) while the repeater is transmitting the received signal using the PTT
control (Repeat/ Network/ Console).
The repeater can continue transmitting for the length of time configured in Repeater Hold Time even if the
communication using the PTT control (Repeat/ Network/ Console) is finished.
Configuration
Repeater Hold Time
Repeater Hold Time
Enable/Disable
Note
・ If "Off" is configured in Repeater Hold Time, the repeater terminates transmitting immediately after reception stops.
While the Repeater Hold Time is counting down, the repeater mutes the transmission audio.
・
・
If Repeater Hold Time is disabled while the Repeater Hold Time is counting down, the Repeater Hold Time continues to
count down and the transmission continues. Repeater Hold Time becomes disabled after the transmission ends upon lapse
of the time configured in Repeater Hold Time.
・ Repeater Hold Time is enabled for analog transmission only (DMR Mode).
・ This function works during transmission by Repeat PTT/ Network PTT/ Console PTT. Also, the behavior occurs during the
NXDN transmission of a Group Call by SIP PTT as well.
Configuration using KPG-D7
Configuring Repeater Hold Time ( Edit > Optional Features > Common Page 1 > Repeater/ External/ Network/
・
Console PTT > Repeater Hold Time)

Temporarily Disabling the Squelch (Squelch Off)

6.3
Squelch Off is the function to unmute the speaker. Enabling Squelch Off disables the signaling decode by QT/DQT,
and the speaker is unmuted. If Squelch Off is enabled for an analog channel, RX1 LED lights green even if the
repeater is not receiving, and the speaker is unmuted regardless of the QT/DQT Decode configuration.
Squelch Off can be toggled between enabled and disabled when a signal is applied to an AUX Input port, or when the
repeater is turned on.
FUNC (E)/ Ver 2.00
Table 6-1 Configuration of Repeater Hold Time
Description
The length of time during which transmission continues after the reception by the
repeater stops is configured.
Repeater Hold Time can be toggled between enabled and disabled by using
Repeater Hold Time Enable/Disable in the Remote Control function of the Web
Tool.
To execute the above, the function needs to be preconfigured by the FPU to be
available.
102